E dopo CPU-Z anche SpeedFan si aggiorna alla versione 4.27 apportando diverse migliorie in fase di riconoscimento dei sensori di temperatura e del chipset della scheda madre. Eccovi la descrizione del software e l'elenco delle migliorie con questa nuova versione:
SpeedFan is a freeware program that monitors fan speeds, temperatures and voltages in computers with hardware monitoring chips. SpeedFan can even access S.M.A.R.T. info for those hard disks that support this feature (almost all :-)) and show hard disk temperatures too, if supported. SpeedFan can even change the FSB on some motherboards. At the lowest level, SpeedFan is an hardware monitoring software, but its main feature is that it can control the speed of the fans (depending on your sensor chip) according to the temperatures inside your pc, thus reducing noise and power consumption. Most Winbond sensors and ASUS AS99127F support fan speed changing, as well as others from MYSON, ANALOG DEVICES, NATIONAL SEMICONDUCTORS and ITE, but the motherboard should make use of available pins. This means that if you have, say, a W83782D on a BP6 then you're ok. If you have a W83782D on some GigaByte's... you're not :-)
SpeedFan works fine with Win9x, WinME, WinNT, Win2k and WinXP.
Migliorie versione 4.27
added full support FINTEK F75387 support
added full support for PHILIPS SA56004X
added support for FINTEK F71872F
properly enabled ICH6 SMBus when needed
added full support for SiS965 SMBus
events now play BEEP through the speaker's driver at a lower level
added full support for ANALOG DEVICES ADT7476
fixed a bug in the installer that prevented installing under some circumstances
added support for nVidia GeForce 6800 NV48 and 6610 XL
DELL support was extended to ICH7 motherboard models
Aggiungi un commento